The installation of almond kernel slicing machine

Almond kernel slicing machine is mainly used to cut various kinds of nuts into slices. It can be used to cut peanut, almond, cashew nuts, etc. How to use and install the almond slicer？

Turn on the power and pay attention to whether the spindle cutter is turning clockwise. The motor of the almond slicer machine is an electromagnetic speed-regulating motor. The speed of the cutter head can be adjusted according to the actual requirements of the material.
You shall note that the speed controller should be returned to the zero position each time when the machine is turned on or off, which can avoid the damage to the speed controller.
Connect the gas source, connect the clean compressed air from the pressure regulating valve with the 8mm outer diameter air pipe, and adjust the air pressure to 0.3-0.4Mpa. The working pressure of the cylinder of almond slicer can not be adjusted too high. If it is too high, the cutter will vibrate and make the slice thickness uneven. If the pressure is too low, the pieces will be broken.
you can change the working frequency of the cylinder. Generally, the lifting time of the cylinder is generally 3-4 seconds. The pressing time is generally adjusted to 15-30 seconds according to different thickness and cutter speed, and itis based on the time when the nuts can be fully cut.
Adjust the thickness of the slice. The operator places the selected and cleaned nuts into feeding hopper to continuously cut them. When adjusting the thickness, you can loose the lock nut, and the handle is adjusted clockwise to increase the thickness. Conversely, the thickness is reduced. The thickness is 1.5 mm when the lock nut is rotated for one circle. It also can be adjusted as required. After adjusting, you should re-lock the nut.
Replace the blade. This almond slicer machine is equipped with two high-speed steel blades on the rotary cutting disc. When the blade edge is blunt and not sharp or when the nuts are mixed with sand and small stones, the blade must be replaced in time.

Our almond slicer is made of stainless steel, which makes the machine safe and hygienic when cutting nut kernels and has a long service life. Having this type of nut slicer can save you a lot of time, money, and effort when it comes to processing nuts. And our almond slicing machine price is quite competitive and the machine is cost-effective.